Water Heater Grand Prairie TX

+Water Heater Grand Prairie TX 👋
((How to [Flush] a Water Heater ?)) 👌

Part 1
Flushing the Heater

1- Locate the breaker/fuse box for an electrical heater or the thermostat for a gas heater.
2- Disable the circuit or fuse that powers the electrical water heater, or turn the thermostat to "Pilot" on a gas heater.
3- Turn off your cold water supply by rotating the water shut-off valve clockwise.
4- Open the hot water faucet in your sink or tub.
5- Attach a garden hose to the drain cock, or valve, located at the bottom of the heater.
6- Extend the garden hose to a place where the water from the heater can safely discharge.
7- Open the drain cock to allow the water to exit the heater.
8- Fill a "test" bucket with the still flushing water after a few minutes of flushing.

Part 2
Finishing Up

1- Close the drain cock and remove the garden hose.
2- Turn the water supply back on and let the tank fill.
3- Close the water heater drain.
4- Turn the water supply back on and wait until the hot water line begins running continuously.
5- Turn off the tub spigot.

www.waterheatergrandprairietx.com 😍
972-591-3598

water_heating
electrical_water_heater
plumbers_near_me
hot_water_heater
electric_water_heater
plumbing_services
emergency_plumber
water_heater_repair
Water_heater_installation
commercial_plumber
Water_Heater_Grand_Prairie_TX
Plumbing_Grand_Prairie_TX